RCBS Power Pull II Blt Puller with 3 Chucks
Product Number: RC9412
Our Price: $19.99
Regular Price: $21.99
Availability: In stock
Details & SpecsReviewsQuestions
The RCBS Power Pull II Bullet Puller is a handheld tool designed to make it easier for your to separate your bullets from the case. This tool was designed with a rugged one-piece polymer body along with a three-jaw chuck that securely grips the rim of the case. All you have to do then is tap the tool on a solid surface, and both the powder and the bullet will drop into a collection chamber.
The three case holding chucks will accommodate cases from 5.7x28mm and .22 Hornet up through the WSM and RUM family of cartridges. Note: Not for use with rimfire cartridges.1RCBS Power Pull II Blt Puller with 3 Chucks is rated out of 5 by 2.Rated 5 out of 5 by 1961weasel from Just get one! I finally bought one of these after any years of pulling suspect loads "manually". This is much easier, and far less damaging to components. It didn't take long for me to get the "feel" of the tool, and get the technique down. The only advice I would offer, however, is to read and follow the instructions exactly. In particular, check the cap to ensure it is tight before EACH strike. It WILL loosen, and this can cause damage to the collets. Keeping the cap tight will help prevent the case rim from "slapping" the collet and breaking it. And, remember: it is NOT a hammer. You are trying to remove the bullet, not drive a nail! I just wish I had gotten one of these a long time ago. Everybody who reloads should have one on-hand, just in case.Date published: 2015-09-25Rated 5 out of 5 by Rocketman from RCBS BULLET PULLER. GOOD EQUIPMENT. RCBS equipment is always sturdy, well made and among the best money can buy. The RCBS bullet puller I just bought is as good or better than the one I had for over 25 years and used many times before it was lost during a recent move. I have never been disappointed in any piece of RCBS equipment.Date published: 2015-06-131